Category: Flight Simulator X - AFCAD Files
Salem Airfield Airport (NJ74), NJ

File Description:
Located 01 miles E of Salem, New Jersey on 14 acres of land, Salem Airfield is a private turf strip 2200' in length. The hard surface runway has been removed so have your mesh settings as high as possible to get the most out of landing/taking off on actual terrain. The surrounding area has been highly detailed with as much forestation as possible included to block out the horizon as much as possible considering the many open spaces surrounding the airport. Tie downs are located next to the middle of the runway, look for the marker cones or start in any RAMP_GA_SMALL parking locations. A hangar is available as well, and attendant is on call on NAV2 to open the door. You can start inside the hangar in the DOCK_GA parking spot or outside the hangar in the RAMP_GA parking spot. All parking is for aircraft with wingspans no greater than 40 feet. There is no fuel available. The field is lit for night use, but the windsock is not so check your weather before flying in! Scenery constructed with use of satellite images/streetview/aerial photos - the author has not been there in person. This scenery is meant to be used in conjunction with MegaScenery Earth New Jersey/Delaware 004. It is not required, but apron use is minimized to allow satellite scenery to show through as much as possible, and objects are placed based on the MSE textures - lack of it may make scenery look out of place.

Filename:	Salem_Airfield_Airport_NJ74_NJ.zip
License:	Freeware
Added:	10th August 2011, 02:05:51
Downloads:	176
Author:	Drew Sikora
Size:	910.96 KB

Category: Flight Simulator X - AFCAD Files
Ekdahl Airport (NJ59), NJ

File Description:
Located 04 miles S of Freehold, New Jersey, Ekdahl Airport is a private turf strip 1300' in length bordered closely by trees. This makes for an interesting landing as the 90' width of the runway is all the room you have to play with. However because it can be difficult to gauge your distance to trees and also because even the slightest brush with a tree can cause a crash, all trees immediately adjacent to the runway have crash disabled - mainly so you can turn your plane around if you land on Runway 02. The hard surface runway was removed so make sure your terrain mesh complexity is set as high as possible to get that bumpy ground realism. A windsock is listed as being available on this field but I could not locate it in any imagery and so placed it by default near the hangar building. You can start on the runways or parked in front of the hangar. Make sure your plane is capable of these take off and landing distances! Tree height around the field was not listed so I again used my best judgement from studying aerial photos. There is no fuel or parking for transient aircraft available. The field is not lit - daytime VFR operations only are recommended. Scenery constructed with use of satellite images/streetview/aerial photos - the author has not been there in person. This scenery is meant to be used in conjunction with MegaScenery Earth New Jersey/Delaware 002. It is not required, but apron use is minimized to allow satellite scenery to show through as much as possible, and objects are placed based on the MSE textures - lack of it may make scenery look out of place.

Filename:	Ekdahl_Airport_NJ59_NJ.zip
License:	Freeware
Added:	13th August 2011, 16:53:55
Downloads:	172
Author:	Drew Sikora
Size:	550.03 KB

Category: Flight Simulator X - AFCAD Files
Peaslees Airstrip Airport (NJ25), New Jersey

File Description:
Located 01 miles SW of Clarksboro, New Jersey on 8 acres of land, Peaslees Airstrip is a private turf field 2207' in length. The hard surface runway has been removed to allow for landings on terrain, so have your terrain mesh set as high as possible. The surrounding area of rural farmland and houses has been filled in to provide an encompassing ground environment with as few breaks to the horizon as possible. There are no services at this airport - if you arrive there is room past the hangar to park and tie down although no tie downs are available in real life, thus you can only start from this airport on the runway. The windsock is located approximately midfield of the runway, as in real life. A second hangar has been constructed nearby the current one, but MSE textures do not reflect this and it was not included. This airport is not lit and daytime VFR operations only are recommended. Scenery constructed with use of satellite images/streetview/aerial photos - the author has not been there in person. This scenery is meant to be used in conjunction with MegaScenery Earth New Jersey/Delaware 004. It is not required, but apron use is minimized to allow satellite scenery to show through as much as possible, and objects are placed based on the MSE textures - lack of it may make scenery look out of place.

Filename:	Peaslees_Airstrip_Airport_NJ25_New_Jersey.zip
License:	Freeware
Added:	20th August 2011, 19:56:22
Downloads:	160
Author:	Drew Sikora
Size:	1 MB

Category: Flight Simulator X - AFCAD Files
Warren Grove Range Airport (NJ24), New Jersey

File Description:
Located 03 miles SW of Burlington County, New Jersey, Warren Grove Range is a private concrete airfield 1800' in length. It is owned by the Department of Defense and exists in a restricted flight area. The bare sand of this area has washed out the satellite images tremendously from over-exposure thanks to reflected sunlight - you can't even make out the runway (which FSX places incorrectly over a mile away). Due to lack of ground definition and primary use as a military facility, this airport has not been developed by MSEAirports and the concrete runway has been removed. Scenery constructed with use of satellite images/streetview/aerial photos - the author has not been there in person. This scenery is meant to be used in conjunction with MegaScenery Earth New Jersey/Delaware 003. It is not required, but apron use is minimized to allow satellite scenery to show through as much as possible, and objects are placed based on the MSE textures - lack of it may make scenery look out of place.

Filename:	Warren_Grove_Range_Airport_NJ24_New_Jersey.zip
License:	Freeware
Added:	20th August 2011, 19:58:05
Downloads:	174
Author:	Drew Sikora
Size:	153.47 KB

Category: Flight Simulator X - Miscellaneous Files
T-6 Texan Pack Mods

File Description:
Sky Unlimited Texan Pack Mods. This includes a new voicepack file that adds "Texan" to the aircraft model category, a revised checklist that was constructed based off an authentic training video for the Texan and tested in the sim, and instructions on how to modify your aircraft.cfg file to use the new voicepack and the panel.cfg file to fix some issues with the radio stack window.

Filename:	T6_Texan_Pack_Mods.zip
License:	Freeware
Added:	22nd August 2011, 19:17:53
Downloads:	193
Author:	Drew Sikora
Size:	6.48 KB

Category: Flight Simulator X - Sounds
KPRB ATC Voicepack Mod

File Description:
Uses Edit Voicepack to replace "KPRB Traffic" with "Paso Robles Traffic" in ATC comms

Filename:	KPRB_ATC_Voicepack_Mod.zip
License:	Freeware
Added:	22nd August 2011, 19:18:24
Downloads:	154
Author:	Drew Sikora
Size:	1.46 KB

Category: Flight Simulator X - Sounds
KSBP ATC Voicepack Mod

File Description:
Uses Edit Voicepack to replace "KSPB" with "San Luis" in ATC comms

Filename:	KSBP_ATC_Voicepack_Mod.zip
License:	Freeware
Added:	25th August 2011, 00:41:08
Downloads:	161
Author:	Drew Sikora
Size:	1.27 KB

Category: Flight Simulator X - Sounds
L52 ATC Voicepack Mod

File Description:
The purpose of this voicepack mod is to replace "Lima 52 Traffic" with "Oceano Traffic" in CTAF communications

Filename:	L52_ATC_Voicepack_Mod.zip
License:	Freeware
Added:	25th August 2011, 05:36:41
Downloads:	100
Author:	Drew Sikora
Size:	1.4 KB

Category: Flight Simulator X - AFCAD Files
Malone Airport (NJ61), NJ

File Description:
Located 02 miles E of Frenchtown, New Jersey on 45 acres of land, Malone is a private airport with two turf strips, the longest of which is 2400' in length. There are no services offered, although there is room next to the existing planes to park if you wish - collisions are disabled with the aircraft. Both runways have their hard surfaces removed so turn your mesh settings as high as possible. Both runways slope down from the hangar/house area. Airport is unlit and daytime VFR operations only are recommended.

Scenery constructed with use of satellite images/streetview/aerial photos - the author has not been there in person. This scenery is meant to be used in conjunction with MegaScenery Earth New York 007. It is not required, but apron use is minimized to allow satellite scenery to show through as much as possible, and objects are placed based on the MSE textures - lack of it may make scenery look out of place.

Filename:	Malone_Airport_NJ61_NJ.zip
License:	Freeware
Added:	20th September 2011, 13:57:18
Downloads:	284
Author:	Drew Sikora
Size:	958.34 KB

Category: Flight Simulator X - Sounds
KBLM Voicepack Mod

File Description:
The purpose of this voicepack mod is to replace "KBLM Traffic" with "Monmouth Executive Traffic" in CTAF communications and also to replace "Choose option for KBLM Traffic" with "Choose option for Monmouth Executive Traffic" in the ATC display window. It will also change the weather service identifier in the ATC window however the automated message will still pronounce the airport's phonetic name. NOTE: The AWOS modification requires that the AFCAD you are using for KBLM have the AWOS name entered. By default it is not. An AFCAD that does include this is my KBLM scenery (http://www.mseairports.com/index.php?page_id=592)

Filename:	KBLM_Voicepack_Mod.zip
License:	Freeware
Added:	20th September 2011, 14:05:46
Downloads:	115
Author:	Drew Sikora
Size:	2.53 KB